This is the kind of jacks I have.

Attached Images

Cat5KeystoneJack2.JPG (26.0 KB, 9 views)

__________________
So many home haunting ideas and yet so little time.

hmmm, dont know 'bout those then.. My first controller is with jacks an sockets, th' other two controllers will be hard-wired(no sockets), too pricey, $30 fer 10 sockets, but they still be soldered.

__________________

Pirate Fonts, Music an' VSA Page: www.slavjane.org/halloween/pirates.html

You be needed to check the Bay of E fer yer deals. I found these little darlins fer $2 each and shipping was very reasonable. Now ya got me doin it.

__________________
So many home haunting ideas and yet so little time.

Aye, bu' tis easier jus' ta put the servo pigtail on th' board end o' th' cable, solder th servos right to the skull end of th cable an just use a cable clamp ta hold'em oll together an keep the strain off the wires.

__________________

Pirate Fonts, Music an' VSA Page: www.slavjane.org/halloween/pirates.html

Ok. Looking over your lines on the RJ45 plug and comparing it to a regular RJ45 jack setup, I found the following:

Left Side:
Jaw: Solid Orange
Red Power: Striped Orange
Red Power: Striped Green
Empty: Striped Blue (should be black ground)

Right Side:
Black Ground: Striped Brown
Servo: Brown
Servo: Green
Servo: Blue

Does it look like I have it right?

__________________
So many home haunting ideas and yet so little time.

Yer dark striped wires, th' striped blu an' striped brown, shud be run together, ta provide enough current 'andlin' capability, an' look like ye got it labeled right. Ye can solders them together, then fits'em inta th' black ground socket..

Again, it jus' th' wirein' code I be usin', if ya 'as yer own code, by oll means, if it stikes yer fancy, or more sense it be makin'. then 'ave at it..

Jack

__________________

Pirate Fonts, Music an' VSA Page: www.slavjane.org/halloween/pirates.html